Wafer 416-T

In the study, which combines the compressed sensing (CS) and the structured illumination microscopy (SIM) methods, an object plane should first be collected by a lens, and then the collected signal should be measured by a photomultiplier tube (PMT), located at the focal point of the lens. The recorded measurements present a measurement vector that…

In order to include pumps on the prototype blood analyzer cartridges, it was necessary to implement a small pump using the existing knife-cut PDMS layer layup technique. The diaphragm architecture was selected due to ease of operation and minimal additional part requirements. CAD model of pump in Autodesk Inventor Bottom view of fabricated pump. The…

Hello everyone,   After some work on GoDaddy’s side, we have fixed the HTTP error when trying to upload images. Please let me know if you encounter this issue in the future. Cheers!

Production this week yielded mixed results. We ran eight wafers through four different RTP temperatures with/without the susceptor. We wanted to test our theory that temperature non-uniformity inside the chamber was causing the morphology change across the wafer. This proved to not be the case! Wafers that were treated with and without susceptor showed the…

Introduction: This post presents a comprehensive protocol detailing an in vitro seeding and culturing method tailored for diverse cellular monolayer and tissue interfaces. These interfaces necessitate varying culturing conditions and extended timeframes, facilitated through modular device utilization. The methodology focuses on endothelial cells interfacing a three-dimensional (3D) tissue construct, demarcated by a porous membrane within…