Alec’s Proposal Exam Documents
Here are my proposal exam materials for reference.
Proposal Document: Proposal_Salminen
Proposal Presentation (No Animations or Videos): Proposal Presentation_No Animations
Here are my proposal exam materials for reference.
Proposal Document: Proposal_Salminen
Proposal Presentation (No Animations or Videos): Proposal Presentation_No Animations
A change in open-circuit potential, measured across a pnc-Si membrane, in response to a fluctuation in flow rate of electrolyte solution exhibits a promising flow-sensing capability of the membrane. To demonstrate this correlation, the open-circuit potentials were measured under a variety of pressured-driven flow patterns. In Figure 1, a series of flows under various applied…
Introduction The Membrane Flow Analysis Device for Gas (MFAD-G), Quality Control Model, is the first* of a 3-version series of devices that, altogether, will allow use-specified measurement of flow rate and flow pressure of gas and liquid media through chip-mounted membranes. The QC Model has a rudimentary form of the general system and acts as…
Manufacturer’s Data Logged by: Ahmet Gurcan Membrane Type: MSSN 8 micron Microslit – Gold Coated SKU: MSSN400.C-3LX.1-8.0K2-AU Lot Number: 251028-10 Quantity Received: 200 Manufacturer Test Report: Flow Data Avg in SLPM 15psi: 7.6 Burst: 16.1 PSI
Jirchai summarized his data in this table … A question raised by a reviewer of our PNAS submission – and one that we’ve had for a long time – is what is the efficiency of the pump. The electrical power provided is calculated in the table for each configuration. As Chris mentioned in group meeting,…
I tried to clean samples from W615 using UV/ozone to cleanse the membranes of the organic impurities we have been seeing lately. I followed the UV/ozone protocol, with a stage temp of 25C and treatment time of 5 minutes. No change in the impurities were observed; I plan on trying to run it again for…
Fibroblast adhesion experiment was done using poly-lysine coated plastic and teflon coverslips as positive and negative controls repectively. Poly-lysine is a polypeptide that gives the cells a sticky surface to adhere to. Teflon coverslips are used as negative control because they do not promote cell adhesion. Difference in morphology of cells could also be seen…