I ran a 30 hour urea clearance with 100% serum through the single slot dialysis device. The now standard protocol was run. The single slot chip was annealed in the RTP for robustness then clamped into the acrylic/PDMS flow fixture. Ethanol was pumped through the chip for 1 hour, then degassed PBS was pumped for…
What process flows have I used to create my devices? Standard Cut out gaskets (10 min) Embed Electrode (face down) (3 hrs) Ozone Bottom, Interstitial, Filter and Top channels together (1 hrs, cure overnight) Ozone Bottom Electrode (1 hr, cure overnight) Ozone Top Electrode + Feet (1 hr, cure overnight) Weaknesses are that there are…
Dr. Webb is very interested in the thin nanomembranes that our group experiments with. To date, he has been trying to get cells to grow on SiN microporous material and image them with a few different types of microscopy (Phase, Confocal, Scanning Conductance Ion Microscopy). The cells have not grown well natively on the nitride…
The Cambridge Microsystems Savannah 200 atomic layer deposition (ALD) system uses a two-step chemical process that alternates pulses of water vapor and trimethylaluminum (TMA) to build a layer of Al2O3 on a silicon substate. Because of the two-step nature of the process, the film is forced to grow by successive monolayers, each with a thickness…
Karl and I have been working to measure separations using SEPCONs with particles ranging in size from 20 nm to 1 µm. We started out naively enough by slightly diluting some flourospheres we found in the refrigerator, putting them in the TECAN’s nanoquant plate and pressing run. I know. Ha ha. The first point we should…
I created some quick open air devices to test the viability of different adhesion molecules. The basal well has a volume around 150 uL, and the apical well has a volume around 15 uL. I made 6 devices in this format. On 5/14/13, Alan and I filled the basal chamber with PBS and then…
In my previous post talking about the contact angle measurement of 3-mer coated PEG, there was a lack of adequate controls, and also an unanswered issue of contamination of samples during storage. I would now like to refine the study in more -controlled fashion, and without reusing the old chips. In addition, I am also…
I found this article about a macro-microfluidic interconnect that I want to try out at some point. We might even be able to seal tube-block interface with PDMS for a tighter seal. http://blogs.rsc.org/chipsandtips/2006/11/13/a-simple-interface-between-a-pdms-microfluidic-device-and-a-syringe/ A simple interface between a PDMS microfluidic device and a syringe 13 Nov 2006 By Francesca Burgoyne. Jeonggi Seo and Meng…
I made a lot of 6 devices for Vaccinex. We attempted to seed human endothelial cells on the membranes, flowing at 20 uL/min, first coating the surface of the membrane with an adhesion molecule at 20 uL/minute. At the same time, the same cell line was grown in a 24 well TEER z-scope tool to…
Quick review of “Achieving more frequent and longer dialysis for the majority: wearable dialysis and implantable artificial kidney devices” by Fissell, Roy, and Davenport see Fissell(Roy)_2013_International_Kidney.pdf in the hemodialysis section of the library. First a little background: Two type of wearable devices: Peritoneal Dialysis (PD) and Hemodialysis (HD) In PD, dialysate is pumped into and…